Ez-Link System Dual Installation - Rheem 874 Owner's Manual And Installation Instructions

EZ-LINK SYSTEM DUAL INSTALLATION

The EZ-Link™ system is designed to electronically control two continuous flow gas water heaters and have
them operate as one. One or both water heaters may be in operation, depending upon the hot water
demand. The second water heater will only operate when the hot water demand exceeds the capacity of the
first water heater to supply.
The EZ-Link system is suitable for installation with Rheem 864 and 862 series continuous flow gas water
heaters. The Ez-Link Kit PN 290141 is required for the installation.
cable clamps
x 2
Ez-Link Cable
Cable Clamp
Screw
Notes:
Only two continuous flow gas water heaters can be installed with an Ez-Link system.
The Ez-Link system will vary the start up sequence of the two water heaters.
The two continuous flow water heaters must be of the same model. The performance of two different
model water heaters manifolded together cannot be guaranteed.
A temperature controller is not required to be installed with the EZ-Link system.
If required, the controller can be either a standard or deluxe controller.
A maximum temperature of 55˚C if a kitchen controller is used.
Warning: Two continuous flow water heaters manifolded together with an Ez-Link system installed
cannot be used as an in-series gas booster system to a solar water heater installation. Temperature
controllers must not be fitted to a water heater as part of a solar water heater system because water at a
temperature much higher than the controller setting can be delivered.
Ez-Link cable x 1
screws x 2
x 1 Warning Label
Ez-Link Kit – PN 290141
x 2 AGA Label
x 2 + Installation Instruction
EZ-LINK KIT (290141)
DO NOT OPERATE THIS APPLIANCE BEFORE
READING THE INSTRUCTION
BOOKLET.
DO NOT PLACE ARTICLES ON OR AGAINST
THIS APPLIANCE.
DO NOT STORE CHEMICALS OR FLAMMABLE
MATERIALS, OR SPRAY AEROSOLS
NEAR THIS APPLIANCE.
DO NOT OPERATE WITH PANELS, COVERS
OR GUARDS REMOVED FROM THIS
APPLIANCE.
DO NOT ENCLOSE THIS APPLANCE.
CERTIFIED FOR OUTDOOR INSTALLATION ONLY
To operate the water heater
Open the inlet water and gas valves fully
Plug appliance into mains power outlet and switch on
Turn on remote temperature controller(s) if fitted
Open a hot tap - the heater will operate automatically
To shut down the water heater
Close the inlet water and gas valves fully
Turn off remote temperature controller(s) if fitted
If power will be disconnected, refer to the owners guide
regarding draining the appliance to avoid damage due to
freezing
N199
warning label x 1
(121109)
x 1 (121109)
x 1 (121901)
56
AS 3498
WMKA21434
121109 AD
AGA label x 1
(121901)
x 1 (122139)