Inserting Batteries - Olympus DS-330 Instructions Manual

Inserting Batteries

1
2
3
...............................................................................................................................................
Notes
• Be sure to stop the recorder before replacing the batteries. Unloading the batteries while the recorder is
recording, erasing or otherwise accessing an audio file may corrupt the file. If you are recording into a file and
the batteries run out, you will lose your currently recorded file because the file header will not be able to close.
So, it is crucial to change the batteries once you see only one mark in the battery icon
• Be sure to replace both batteries at the same time.
• Never mix old and new batteries, or batteries of different types and/or brands.
• If it takes longer than 1 minute to replace dead batteries, you may have to reset the time when you load fresh
batteries. ( P.10)
• Remove the batteries if you are not going to use the recorder for an extended period of time.
8
1
Lightly press down on the arrow and slide the
battery cover open.
2
Insert two AAA alkaline batteries, observing
the correct polarity.
3
Close the battery cover completely.
Replacing batteries
The battery indicator on the display changes as the batteries
lose power.
→
When appears on the display, replace the batteries as
soon as possible.
When the batteries are too weak, the recorder shuts down
and "BATTERY LOW" appears on the display. AAA alkaline
batteries are recommended.
→ →
"BATTERY
LOW"