Pre-Assembly - Horizon Fitness Cst 3.6 club series User Manual

Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to
lift the treadmill at this time. Remove plastic wrap from console masts.
NOTE:
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
A S SE MB LY S T E P 1
HARDWARE BAG 1 CONTENTS :
LEAD WIRE
FLAT WASHER (B)

Downloaded from www.Manualslib.com
P R E -A S SE M BLY
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
BOLT (A)
manuals search engine
BOLT (A)
65 mm
Qty: 4
CONSOLE CABLE
A
Open HARDWARE BAG 1.
B
Pull LEAD WIRE through RIGHT
CONSOLE MAST to drag upward.
C
Place RIGHT CONSOLE MAST
into upright position using 2
BOLTS (A) and 2 WASHERS (B)
and tighten. Be sure to hold the
console mast firmly, as it will
not stay in the upright
position on its own.
D
Repeat on the left side. Note:
There is no wire in the LEFT
CONSOLE MAST.
FLAT WASHER (B)
8 mm
Qty: 4