Operation; Selecting An Input Source; Using Picture-In-Picture (Pip) - Runco Q-750i Installation And Operation Manual

When you turn on the Q-750i, it switches to the last selected input and looks for a valid
signal.
Use these buttons on the remote control to select an
input source directly.
You can assign the HD 1, HD 2 and HD 3 buttons to any
input. The default assignments are:
HD 1 = Component 1, HD 2 = Component 2,
HD 3 = RGB.
For more information, refer to HD 1 Key / HD 2 Key / HD 3 Key on page 66.
For PIP purposes, there are three groups of inputs separated by their display modes:
• Video (SD) group: Video, S-Video and SCART inputs.
• Graphic (HD) group: Component 1, Component 2 and RGB inputs.
• Digital Video group: HDMI 1 and HDMI 2 inputs.
PIP shows one input from any of these groups within or beside one input from either of the
other two groups.
For more information, refer to PIP Position on page 63.
Q-750i Series Installation/Operation Manual
SOURCE
VID S-VID HDMI1 HDMI2
HD1 HD2 HD3
43

4. Operation

4.1
Selecting An Input
Source
4.2
Using
Picture-In-Picture (PIP)