Operators Requirements; Maintenance Technician; Supply Operator; User - Saeco ROYAL OFFICE SUP 015V Operation And Maintenance

Cleaning
Before cleaning the machine, turn the main switch off and
disconnect the power supply. Wait until the machine is cold.
Do not soak the machine in water! Do not disassemble the
machine or perform any operation on the internal compo-
nents of the machine.
Repairing and maintenance
In case of failure or faults possibly after a fall, immediately
unplug the machine. Do not turn the faulty machine on.
The machine can be repaired only by Approved Assist-
ance Centres. The Manufacturer declines responsibility for
damage and injuries caused by incorrect repairing of the
machine.
In case of failure and/or malfunctioning contact exclusively
qualified ASSISTANCE SERVICE repairmen.
In case of fire use Carbon Dioxide extinguishers (CO2).
Do not use water or dry-powder extinguishers.
4.2

Operators requirements

To guarantee the safety and good functioning of the ma-
chine two operators with different skills are required:

Maintenance technician

A specialized technician in charge of machine installation,
set-up, maintenance and technical assistance.

Supply operator

An operator in charge of turning the machine on/off, sup-
plying products, removing coins and of the internal and
external cleaning of the machine.
If the machine is malfunctioning, the supply operator must
request the intervention of the maintenance technician.

User

The person who uses the machine. Users must NOT per-
form any of the tasks of the supply operator or the mainte-
nance technician.
If the machine is malfunctioning, users should request the
intervention of the supply operator or the maintenance tech-
nician.
4.3

Safety devices

All the components that can be potentially dangerous are
located inside the machine.
A microswitch (ref. 1 - Fig. 4) automatically cuts the power
out if the side door is open.
4.4 Safety microswitch efficiency
test
When the machine is on, open the side door and check
that the display (ref. 8 - Fig. 1) and LEDs on the control
panel keypad (rif.8 - Fig. 1) turn off.
If the display and LEDs are off the machine is turned off
and the microswitch is working correctly.
Fig. 4
English
1