Operators Requirements; Maintenance Technician; Supply Operator; User - Saeco AMBRA SUP 015VR Operating And Maintenance Manual

Cleaning
Before cleaning the machine, turn the main switch off and
disconnect the power supply. Wait until the machine is cold.
Do not soak the machine in water! Do not disassemble the
machine or perform any operation on the internal compo-
nents of the machine.
Repairing and maintenance
In case of failure or faults possibly after a fall, immediately
unplug the machine. Do not turn the faulty machine on. The
machine can be repaired only by Approved Assistance
Centres. The Manufacturer declines responsibility for damage
and injuries caused by incorrect repairing of the machine.
In case of failure and/or malfunctioning contact exclusively
qualified ASSISTANCE SERVICE repairmen.
In case of fire use Carbon Dioxide extinguishers (CO2). Do
not use water or dry-powder extinguishers.
4.2

Operators requirements

To guarantee the safety and good functioning of the ma-
chine two operators with different skills are required:

Maintenance technician

A specialized technician in charge of machine instal-
lation, set-up, maintenance and technical assistance.

Supply operator

An operator in charge of turning the machine on/
off, supplying products, removing coins and of the internal
and external cleaning of the machine.
If the machine is malfunctioning, the supply operator must
request the intervention of the maintenance technician.

User

The person who uses the machine. Users must NOT perform
any of the tasks of the supply operator or the maintenance
technician.
If the machine is malfunctioning, users should request the
intervention of the supply operator or the maintenance tech-
nician.
4.3

Safety devices

All the components that can be potentially dangerous are
located inside the machine.
Two microswitches (ref. 1 – Fig. 4) placed side by side,
automatically cut the power supply if the side door is opened.
1
4.4 Safety microswitch efficiency
test
When the machine is on, open the side door and check that
the display (ref. 8 - Fig. 1) and LEDs on the control panel
keypad (rif.8 - Fig. 1) turn off.
When they turn off, it indicates that the vending machine is
not in operation and that the microswitches are working.
Fig. 4
English
7