Selecting Multis; The Display - Kurzweil Artis SE Musician's Manual

Multi Mode

Selecting Multis

Muting Zones
Pressing a Zone On/Off button will mute or unmute the Zone. An active/unmuted Zone
button has a lit LED. The LED of an inactive/muted Zone button is not lit.
Selecting Multis
When you are in Multi Mode, there a few ways to select Multis.
• To select any Multi in the current Category, press a Program/Multi button.
• To select a Multi in a different Category, press the Category Button of choice and
• To select the Category Default Multi, simply press a Category Button.
• To switch between the Factory and User Multis, press the User Button, followed by
• The Alpha Wheel and the
• If a Multi is assigned to a Favorite Button, pressing that button will go directly to the

The Display

In Multi Mode, the top line of the display shows the current Mode and MIDI transposition.
The lower line shows the Multi ID number and name.
Pop Up Messages
Actions such as moving a controller cause the display to show pop up messages. After a short
time the display returns to show the current Multi.
7-2
then the Program/Multi Button to select from the 8 Multis in the Category.
a Category button and then a Program/Multi button. Unlike factory Multis which
have 8 Multis per category, User Multis have 16 Multis per category. Two sets of 8
User Multis can be selected for each Category by pressing the Bank button.
one at a time. When you reach the end of the Category, advancing further will go to
the next Category.
assigned Multi.
+ –
& buttons allow you to advance through the Multis