Adjusting The Brightness Of The Monitor - Olympus Stylus Tough 8010 Instruction Manual

Adjusting the CCD and the image
processing function [PIXEL MAPPING]
s (Settings 2) PIXEL MAPPING
This function has already been adjusted
at factory shipping, and no adjustment is
needed right after purchase. Approximately
once a year is recommended.
For best results, wait at least one minute
after taking or viewing pictures before
performing pixel mapping. If the camera is
turned off during pixel mapping, be sure to
perform it again.
To adjust the CCD and the image
processing function
Press the A button when [START]
(Submenu 2) is displayed.
●
The camera checks and adjusts the CCD and the
image processing function at the same time.

Adjusting the brightness of the monitor

[s]
s
s (Settings 2)
To adjust the monitor brightness
1 Use FG to adjust the brightness while
viewing the screen, and then press the
A button.
s
BACK
For information on using the menus, see "Using the Menu" (p. 4).
MENU SET OK
Setting the date and time [X]
X
t (Settings 3)
"Setting the date, time and time zone"
(p. 14)
To select the date display order
1 Press I after setting Minute, and use
FG to select the date display order.
Y
2010
Date order
CANCEL
X
M D TIME
. . :
02 26 12 30
Y / M / D Y / M / D
MENU SET OK
EN 47