Printer Takes A Long Time To Start Printing; Toner Rubs Off When You Rub The Printed Surface - Oki C5100 User Manual

Printer takes a long time to start printing.

Possible cause
The printer has to warm
up returning from power
save mode.
The image drum carries
out a cleaning process
to ensure print quality,
which takes time.
The fuser unit adjusts
temperature, which
takes time.
The printer is
processing data from
another interface.

Toner rubs off when you rub the printed surface.

Possible cause
Media Weight and
Media Type settings
may not be appropriate.
Packing materials were
left on the fuser when it
was installed.
Remedy
In the printer menu settings, set power save to a
higher value to increase the length of time before
entering power save mode (
→
POW SAVE TIME
Wait until this process has been completed.
Wait until this process has been completed.
Wait until this data is processed.
Remedy
Set the value of media weight in the menu to
the next heaviest one (
MEDIA WEIGHT
Careful! Fuser my be HOT!
Open the top cover and check to be sure that
all the packing materials were removed from
the fuser. To remove the fuser see "Changing
the fuser unit" on page 355.
C5100 Troubleshooting • 151
SYS CONFIG MENU
).
MEDIA MENU
).
→
YYY