Font Sample Test - Oki 390 User Manual

Font Sample Test

!
The Font Sample Test automatically stops after all the
available fonts print.
!
Wide Carriage Model
Microline 391 Turbo
If you are using 8.5 inch paper to run the test, make sure
the paper width selection in the printer menu is set to
8.5 inches. Otherwise, printing on the platen may
damage the printer. Refer to "Using Yo
The Font Sample Test prints a sample of the fonts standard to
the printer.
The top of the printout has the Printer Model, Emulation,
Country Code, Interface, and Firmware Revision Level for
your printer.
To run the test:
• Turn the printer off, then press and hold the LF key
while turning the printer back on.
To exit the test:
• Press SEL.
LF.eps
LF
Micro Feed
Down
GROUP
SEL.eps
SEL
SEL
MENU
User's Guide: English
|
35