Oki 390 User Manual page 33

4 Make sure the wire feed guide (1) is secured in the sheet
guide.
5 Adjust the paper feed guides (1) for the width of the paper.
Place a sheet of paper in the separator. The paper will feed
into the printer.
32T-33.eps
1
32T-15.eps
1
!
Important!
If the paper does not feed in, remove it. Check the paper
lever position. Make sure the ALARM light is on: if it is
flashing, hold the SHIFT key and press the
CHARACTER PITCH (RESET) key. Reload the sheet
of paper.
!
The factory default setting for the Top of Form (where
the printing should begin) is one inch down from the top
of the page. To change the setting, see "Using Your
Printer, Top of Form (TOF)."
|
User's Guide: English 33