How To Start, Stop The Trails; Trail Mode - Furuno 1835 Operator's Manual

1.24.2

How to start, stop the trails

1. Press the TRAILS key to start the trails and select the trail time. The selected time
with the trail mode is shown at the upper-right corner as in the figure shown below.
The available trail time with the TRAILS key changes according to trail times,
which you turn on in section 1.24.1.
2. To change the trail time, press the TRAILS key until the desired trail time is dis-
played. The trail lengthens with the trail time.
Note 1: To erase the trails, press and hold the TRAILS key until a beep sounds, or
select [All Cancel] on the [Target Trails].
Note 2: To deactivate the trails, press the TRAILS key several times until the trail in-
dications disappear from the display.
1.24.3

Trail mode

You can display the echo trails in true or relative motion.
True mode
The true trails show true target movements according to their over-the-ground speeds
and courses. The stationary targets do not show the trails. The true trails require a
heading signal and position data.
Relative mode
The relative trails show other ships' movements relative to your ship. The stationary
targets also show the trails.
To select the trail mode, do the following:
1. Press the MENU key to open the menu.
2. Use the Cursorpad ( or ) to select [Target Trails] and press the ENTER key.
TRAIL(T)
15 S
Trail indications
True target trails
True trails and relative trails
1. DESCRIPTION OF OPERATION
Trail Mode (T: True, R: Relative)
Trail Time
Relative target trails
1-31