Oki OkiLAN 6120i User Manual page 166

Section 4 - Appendix B - Application Considerations
Configuring SCO UNIX for Printing
with the OkiLAN 6120i
This application note describes the configuration of the
printing system on the Santa Cruz Operation's (SCO)
version of the UNIX operating system. For clarity and
brevity, the following specific names will be used to
represent general devices or concepts.
• lj4 - The local queue name of the SCO system to
which print jobs that are destined for a printer
attached to the OkiLAN 6120i will be directed.
• OKIPRINTER - The host name of the remote
system which is the OkiLAN 6120i. For example,
to telnet to the OkiLAN 6120i and invoke the
OkiLAN 6120i Configuration utility, you would
type telnet OKIPRINTER. A host name is not
required for the OkiLAN 6120i, the IP address
may be used.
• yourqueuename - This is the name of the queue
on the OkiLAN 6120i and must end with 1, 2, 3
or 4 depending on the port selected to service the
print jobs.
If FF, LF or NF are the last two letters of the
queue name, the job will be converted
accordingly. See pages IV-15 and IV-16 for more
information on remote queue names.
Prerequisites
Before you proceed, verify that the following
prerequisites are met:
1. SCO TCP/IP version 1.2 or later must be installed.
2. The name of the OkiLAN 6120i (OKIPRINTER)
and the IP address you wish to assign are in the
"/etc/hosts" file of the SCO machine.
3. The IP address of the OkiLAN 6120i has been
assigned and you are able to telnet to OKIPRINTER
successfully.
OKI OkiLAN 6120i User's Guide IV - 73