Installation / Wire Connection Guide - Clarion CZ104E Owner's Manual And Installation Manual

9. INSTALLATION / WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting ............................................................................................... 12
2) Package Contents .......................................................................................... 12
3) General Cautions ........................................................................................... 12
4) Cautions on Installation .................................................................................. 12
5) Installing the Source Unit ............................................................................... 12
6) Removing the Source Unit ............................................................................. 13
7) Wiring and Connections ................................................................................. 14
8) Connecting the accessories ........................................................................... 14
1) Before Starting
1. This set is exclusively for use in cars with a negative
ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "terminal" before
starting. This is to prevent short circuits during
installation. (Figure 1)
2) Package Contents
Source unit .................................................. 1
Trim ring ...................................................... 1
Mounting bracket ......................................... 1
Screws M5x6 mm ........................................ 4
L-key(removal key) ...................................... 2
Rubber cap .................................................. 1
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you drop
anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
12
CZ104E
Car battery
Figure 1
Special screw(M4x42) ................................. 1
Owner's manual........................................... 1
Power supply cable ..................................... 1
Speaker cable ............................................. 1
Special screw(Front panel lock) .................. 1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner, benzine,
or alcohol etc. For tough dirt,
apply a little cold or warm water to a soft
cloth and wipe off the dirt gently.
4) Cautions on Installation
1. Prepare all articles necessary for installing
the source unit before starting.
2. Install the unit within 30° of the horizontal
plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult your
car dealer beforehand.
Max 30˚
Figure 2
5) Installing the Source Unit
1. Place the mounting bracket into the instrument panel, use a screwdriver to bend each stopper
of the mounting bracket inward, then secure the stopper.
2. Wire as shown in Section 7) .
3. Insert the source unit into the mounting bracket until it locks.
4. Take care of the top and bottom of the trim ring and mount it so that all the hooks are locked.
Notes:
1. Some car models require special mounting kits for proper installation.
Consult your Clarion dealer for details.
2. Fasten the front stopper securely to prevent the source unit from coming loose.
• Console opening dimensions
(182 mm)
Hole
4. Use the enclosed screws for installation.
Using other screws can cause damage.
(Figure 3)
Chassis Chassis
Damage
Max. 6 mm (M5 screw)
Figure 3