Specifications; Installation / Wire Connection Guide; Before Starting; Package Contents - Clarion CZ302E Owner's Manual & Installation Manual

8. SPECIFICATIONS

FM Tuner
Frequency range: 87.5-108.0MHz
Usable sensitivity: 8dBf
Frequency response: 30Hz-15kHz
Stereo separation: 30dB(1kHz)
Signal/noise ratio: >55dB
MW Tuner
Frequency range: 531- 1602kHz
Usable sensitivity (S/N=20dB): 30dBμ
LW Tuner
Frequency range: 153-279kHz
Usable sensitivity (S/N=20dB): 34dBμ
CD Player
System: Disc digital audio system
Frequency response: 20Hz-20kHz
Signal/noise ratio: >94dB
Total harmonic distortion: Less than 0.1% (1kHz)
Channel separation: >60dB
MP3/WMA mode
MP3 sampling rate: 8 kHz to 48 kHz
MP3 bit rate: 8 kbps to 320 kbps / VBR
WMA bit rate: 8 kbps to 320 kbps
Logical format: ISO9660 level 1,2
Joliet file system
USB
Specification: USB 1.0/2.0
Playable audio format:
MP3(.mp3): MPEG 1/2/Audio Layer-3
WMA(.wma): Ver 7/8/9.1/9.2
Bluetooth
Specification: Bluetooth Ver. 2.0+EDR
Profile: HFP (Hands-free Profile)
PBAP(Phone Book Access Profile)
A2DP (Advanced Audio Distribution
Profile)
11
CZ302E
AVRCP (AV Remote Control Profile)
Send/Receive Sensitivity: Class 2
Audio Amplifier
Maximum power output:
180W (45W x 4)
Speaker impedance: 4 (4 to 8 allowable)
Input
Audio input sensitivity:
High: 320mV (at 1V output)
Mid: 650mV (at 1V output)
Low: 1.3V (at 1V output)
(input impedance 10 k or greater)
Aux-in level: ≤2V
General
Power supply voltage:
14.4VDC (10.8 to 15.6V allowable),
negative ground
Pre-Amp output voltage:
2.0V (CD play mode: 1kHz, 0dB, 10k load)
Fuse: 15A
Dimensions of the Main Unit:
188mm Width × 58mm Height × 190mm Depth
Weight of the Main Unit: 1.35kg
178mm 50mm
46mm
170mm
58mm
188mm
Notes:
• Specifications and design are subject
to change without notice for further
improvement.
9. INSTALLATION / WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting ...................................................................... 11
2) Package Contents ................................................................. 11
3) General Cautions .................................................................. 11
4) Cautions on Installation ......................................................... 12
5) Installing the Source Unit ...................................................... 12
6) Removing the Source Unit .................................................... 13
7) Wiring and Connections ........................................................ 13
8) Connecting the accessories .................................................. 14

1) Before Starting

1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery terminal before
starting. This is to prevent short circuits during
installation. (Figure 1)

2) Package Contents

Source unit .......................................... 1
Front panel .......................................... 1
Trim ring .............................................. 1
Mounting bracket ................................. 1
Special screw (M4×42) ........................ 1
Rubber cap .......................................... 1
Screws M5x6 mm ................................ 4

3) General Cautions

1. Do not open the case. There are no 2. Use a soft, dry cloth to clean the case.
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
L-key .................................................... 2
Wire connector .................................... 1
DCP case ............................................ 1
Owner's manual................................... 1
Warranty card ...................................... 1
Special screw (Front panel lock) ......... 1
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.