Installation / Wire Connection Guide - Clarion CX305AU Owner's Manual & Installation Instructions

9. INSTALLATION / WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting ...................................................................... 15
2) Package Contents ................................................................. 15
3) General Cautions .................................................................. 15
4) Cautions on Installation ......................................................... 15
5) Installing the Source Unit ...................................................... 15
6) Wiring and Connections ........................................................ 17
7) Connecting the accessories .................................................. 17
1) Before Starting
1. This set is exclusively for use with a negative
ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "terminal" before
starting. This is to prevent short circuits during
installation. (Figure 1)
2) Package Contents
Source unit .................................................. 1
Trim ring ...................................................... 1
Power supply cable ..................................... 1
Owner's manual........................................... 1
Screws M5x6 mm Double Sems ................. 8
Screws M5x6mm Flush mount .................... 8
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
14
CX305AU
Battery
Figure 1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.
4) Cautions on Installation
1. Prepare all articles necessary for
installing the source unit before
starting.
2. Install the unit within 30° of the
horizontal plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult
your car dealer beforehand.
Max 30˚
Figure 2
5) Installing the Source Unit
1. Before installation, please make sure
proper connections are conducted and
the unit operates normally. Improper
connection may result in damage to the
unit.
2. Use only accessories designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit in the place where
close to hot area to prevent damage to
electrical components such as the laser
head.
5. Install the unit horizontally. Installing the
unit more than 30 degree vertically may
result in worse performance.
4. Use the enclosed screws for
installation.
Using other screws can cause
damage.
(Figure 3)
Chassis Chassis
Damage
Max. 6 mm (M5 screw)
Figure 3
6. To prevent electric spark, connect the
positive pole first and then the negative
pole.
Unit Installation
1. When installing the main unit in NISSAN
vehicles, use the parts attached to the unit
(see " NISSAN"). When installing the
main unit in TOYOTA vehicles, use the
parts attached to the vehicle
(see " TOYOTA").
2. Wire as shown in "Wire Connection".
3. Reassemble and secure the unit in the
dashboard and set the face panel and
center panel.