Table of Contents
Advertisement
8.
If your MFP has a duplex unit installed, press the cover release (1) at the centre of
the unit, open the cover and remove any sheets in this area, then close the cover.
NOTE
If the paper is not advanced enough to grip, pull the duplex unit (2) out of the
machine and remove the paper. Refit duplex unit.
9.
Lift the front cover release and pull open the front cover.
10.
Check inside the cover for sheets in this area and remove any that you find, then
close the cover.
NOTE
If the paper is not advanced enough to grip, rotate roller (1) as shown to
advance the paper.
11.
Pull out the paper tray and ensure that all paper is stacked properly, is undamaged,
and that the paper guides are properly positioned against the edges of the paper
stack. When satisfied, replace the tray.
12.
Close the top cover and press down firmly at both sides so that the cover latches
closed.
1
Troubleshooting > 149
2
1
Advertisement
Table of Contents
