Rack Installation - Liebert UHA1R-0100 User Manual

12 Chapter 2 Single UPS Installation And Commissioning
4. If battery module installation is necessary, take out the support base extensions delivered with the battery module,
and then assemble the support base extensions and the support bases together through the fastenings, as shown in
Figure 2-5.
5. Place the UPS and the battery module (if configured) on the support bases and support base extensions. Each
UPS needs two pairs of the support bases, as shown in Figure 2-6.

2.4.2 Rack Installation

Installation procedures for UPS
1. Install the plastic panel, refer to 2.4.1 Tower Installation for the procedures.
2. Take out the two brackets and six M4 × 10 screws from the accessories of the UPS, and fix the two brackets onto
the battery module using the M4 × 10 screws through installation hole 1, as shown in Figure 2-7.
Figure 2-4 Installing support base
Support base
Support base
extension
Figure 2-5 Installing support base with support base extension
UPS
Support base
Figure 2-6 Installing UPS and battery module
Liebert ITA 10kVA UPS User Manual
®
Support base
Fastening
Battery
module
UPS
Support
base