Liebert UHA1R-0100 User Manual page 19

1. For the tower installation, you need to adjust the display panel; for the rack installation, ignore this step.
2. When adjusting the display panel, you do not need to open the chassis of the UPS.
3. When adjusting the display panel, you must turn off the UPS.
2. Install the plastic panel.
1) Take out the plastic panel from the UPS package.
2) Align the plastic panel with the UPS display panel, and gently press the metal buckles on both sides of the plastic
panel into the square holes on the UPS front panel according to the direction shown in Figure 2-3.
You do not need to take off the UPS when removing the plastic panel. Press the two ends of the plastic panel with hands, and
gently pull out the plastic panel to remove it.
3. Take out the support bases from the accessories, assemble a pair of support bases together through the
fastenings, as shown in Figure 2-4, and put them onto the flat installation table.
Chapter 2 Single UPS Installation And Commissioning
Display panel
1
Figure 2-2 Adjusting display panel
Display panel
Plastic panel
Figure 2-3 Installing plastic panel
Liebert ITA 10kVA UPS User Manual
®
Plastic bracket Spring buckle
2
警告 危 险
Note
Square hole
警告 危 险
Note
3
11