Rack Installation; Figure 11 Pulling Inner Member From Each Slide Rail Assembly; Figure 12 Installing Rear Member Of Each Slide Rail Assembly - Liebert GXT3 User Manual

2.4.2

Rack Installation

NOTE
• When the Liebert
• Mounting hardware and slide rails are sold separately. Contact your local Emerson
• GXT3-1000MT120 cannot be installed in a rack. The unit is a minitower only.
To install a Liebert GXT3 rack/tower UPS in a rack:
1. Unpack the two slide rails assemblies and mounting hardware from the rack-mounting kit
(P/N: RMKIT18-32).
Slide rail assembly includes inner member and front and rear members. They are interchange-
able between left-hand or right-hand. Mounting hardware includes M4 screws and M5 screws.
2. Remove inner member of each slide rail assembly by extending it to its outermost position,
depressing the retaining latch and then pulling inner member from slide rail assembly (see
Figure 11).

Figure 11 Pulling inner member from each slide rail assembly

3. Determine the Liebert GXT3's mounting position inside the racks vertical rails.
CAUTION
!
Reduce the risk of tipping the rack by installing the Liebert GXT3 as low as possible in the
rack.
4. Attach the rear member of each slide rail assembly to the rack's rails with two factory-supplied
M5 screws (see Figure 12).

Figure 12 Installing rear member of each slide rail assembly

®
GXT3
rails or slide rails on each side. The factory-supplied rack mount handles cannot sup-
port the weight of the UPS. They are used to move the UPS into and out of the rack and
attach the UPS to the rack.
representative for these options and any assistance.
™
is installed in a rack, it must be supported by a shelf, fixed
Slide rail assembly
Retaining latch
Inner member
14
Vertical pole
M5 screw (4 pcs)
Rear member
Front member
Installation