Choosing A Place For The Printer - Epson OFFICE 82WD User Manual

R41AC322 User's Guide
O Never disassemble, modify, or attempt to repair the power cord, printer unit, or options
by yourself, except as specifically explained in the printer's guides.
O Unplug the printer and refer servicing to qualified service personnel under the following
conditions:
The power cord or plug is damaged; liquid has entered the printer; the printer has been
dropped or the casing damaged; the printer does not operate normally or exhibits a
distinct change in performance. Do not adjust controls that are not covered by the
operating instructions.
O If you plan to use the printer in Germany, the building installation must be protected by
a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and
over-current protection for the printer.
O When connecting the printer to a computer or other device with a cable, ensure the
correct orientation of the connectors. Each connector has only one correct orientation.
Inserting a connector in the wrong orientation may damage both devices connected by
the cable.
O If damage occurs to the plug, replace the cord set or consult a qualified electrician. If
there are fuses in the plug, make sure you replace them with fuses of the correct size
and rating.

Choosing a place for the printer

Observe the following when choosing a place for the printer:
O Place the printer on a flat, stable surface that extends beyond the base of the printer in
all directions. If you place the printer by the wall, leave more than 10 cm between the
back of the printer and the wall. The printer will not operate properly if it is tilted at an
angle.
O When storing or transporting the printer, avoid tilting it, placing it vertically, or turning it
upside down; otherwise ink may leak.
O Allow spaces behind the printer for the cables, and space above the printer so that you
can fully raise the document cover.
O Avoid places subject to rapid changes in temperature and humidity. Also, keep the
printer away from direct sunlight, strong light, or heat sources.
O Do not place or store the printer outdoors, near excessive dirt or dust, water, heat
sources, or in locations subject to shocks, vibrations, high temperature or humidity. Do
not use with wet hands.
O Place the printer near a wall outlet where the plug can be easily unplugged.
SAFE.FM (A4 size) Rev.D
194
Safety Instructions