Remote Reception - Toshiba e-studio 2802af Fax Manual

3.RECEIVING A FAX
3
The following screen is displayed. Select [RX] and press [OK].
MANUAL FUNCTION
TX 100%
RX
FAX
This screen does not appear if [EASY MANUAL TX/RX] is set to [EASY MODE].
 P.102 "FAX"
4
Put down the handset of the external telephone.
 Remote reception
Faxes are received by using an external telephone when you have an incoming call. This is
convenient if the external telephone is installed away from this equipment.
 For remote reception, an external telephone must be installed beforehand. If an
external telephone is not installed, be sure to set [AUTO] in [RX MODE] of the USER
FUNCTIONS menu.
 P.102 "FAX"
 Set [DIAL] in [REMOTE RX].
 P.102 "FAX"
1
Pick up the handset of the external telephone when you have an
incoming call.
If the incoming call is a telephone call, you can start talking.
2
If you hear a tone (fax signal) through the external telephone,
perform either of the following operations depending on the type of
the lines being used.
Pulse line: Switch the mode to the tone line. Then press [5] and then [*] on the external
telephone keypads. Put down the handset of the external telephone.
Tone line: Press [5] and then [*] on the external telephone keypads. Put down the
handset of the external telephone.
The type of the lines can be identified by the sounds heard during dialing as below.
For accurate information, confirm the contractual coverage subscribed to with your
telephone carrier.
Pulse line (dial line): Sounds like the series of clicks heard when dialing
Tone line (push line): Sounds like a mixture of the two pure tones (pure sine wave)
heard when dialing
4
3 RECEIVING A FAX
Reception Mode 49