Pentax K20D Operating Manual page 264

262
Error Message
Not enough battery remaining
to activate Pixel Mapping
Image folder cannot be
The image is not stored
Settings not stored
Rotation information cannot
be saved to this image
No more images can be
selected
This RAW file cannot be
developed
This image cannot be filtered
No DPOF files
Printer error
No paper in the printer
Printer settings are changed
12
Low paper level in the printer
Low ink level in the printer
Downloaded From camera-usermanual.com Pentax Manuals
created
NG
Description
Appears during pixel mapping if the battery level
is insufficient. Replace the battery with a charged
one or use an AC adaptor D-AC50 (optional).
(p.39)
The maximum folder number (999) and file
number (9999) are being used, and no more
images can be saved. Insert a new SD Memory
Card or format the card. (p.218)
The image could not be saved because of an SD
Memory Card error.
The DPOF settings or rotated image could not be
saved because SD Memory Card is full. Delete
unwanted images and perform DPOF settings or
rotation again. (p.70)
The camera was unable to measure the manual
white balance or detect dust on the sensor. Try
the operation again. (p.163, p.252)
New rotation information cannot be saved to an
image without rotation information.
You cannot select 100 or more images to delete
or edit at a time. (p.186, p.198)
RAW files captured with other cameras cannot
be edited on this camera.
Appears when digital filter is started from Fn
menu for images captured with other cameras.
No file set with DPOF. Set DPOF and then print.
(p.204)
There is an error with the printer and the file
cannot be printed. Fix all the errors and try
printing again.
Printer has run out of paper. Put paper in the
printer and print.
The camera received notification that the printer
status has changed. Press the 4 button to
reconnect to the printer.
Printer is running out of paper. This appears
when this signal is received from the printer. After
two seconds, the printer resumes printing.
Printer is running out of ink. This appears when
this signal is received from the printer. After two
seconds, the printer resumes printing.