Use Of A New Battery - APRILIA tuono v4 Owner's Manual

Use of a new battery (04_08, 04_09)

CHECK THAT THE BATTERY LEADS AND TERMINALS ARE:
- IN GOOD CONDITION (NOT CORRODED OR COVERED BY DEPOSITS);
- COVERED BY NEUTRAL GREASE OR PETROLEUM JELLY.
CAUTION
UPON REFITTING, CONNECT THE LEAD TO THE POSITIVE TERMINAL (+) FIRST
AND AFTERWARDS THE LEAD TO THE NEGATIVE TERMINAL (-).
•
Remove the saddle if refitted.
•
Place the battery (8) in its housing.
•
Fasten the positive cable (7) to the positive terminal (+), tightening the screw
(6).
The positive cable (7) must be positioned to the side of the battery (8).
•
Place the protective rubber cap on the positive clamp (+).
•
Fasten the negative cable (5) to the negative terminal (+), tightening the
screw (4).
The negative cable (5) must be positioned to the side of the battery (8).
04_08
•
Fit the battery retainer (3).
•
Fit the secondary fuse box (2).
•
Tighten the two screws (1) using the spanner supplied in the tool kit.
•
Fit and fasten the rider's saddle as described in the paragraph "opening the
saddle".
104