Table of Contents
Advertisement
WARNING:
All servicing requiring access to non-insulated electrical components must be performed
by a factory authorized technician.
DO NOT open any access panel which requires the use of tools. Failure to follow this warning
can result in severe electrical shock
CAUTION:
Risk of
Damage
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance can result if
these instructions are not
followed.
CAUTION:
Electrical Shock
Hazard
The ground lug of this
appliance must be connected
to a suitable building ground.
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
IMPORTANT: Oil must be
drained into a container
approved for the disposal of
hot oil.
IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
INSTALLATION (continued)
Electric Shock Hazard
UNPACKING & INSPECTION
Carefully remove the fryer from the carton. Remove all protective
plastic film, packing materials and accessories from the fryer before
connecting electrical power or otherwise performing any installation
procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the fryer before starting any installation.
Read and understand all labels and diagrams attached to the fryer.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
COMPONENTS
1 ea.
Frypot
1 ea
Frypot Drain Valve
1 ea.
Fryer Basket
INSTALLATION SETUP IN SPECIALLY PREPARED COUNTER
Be sure the fryer is firmly secured to the countertop.
IMPORTANT: DO NOT block the ventillation holes in the bottom of the
control section. Blocking these holes will lead to failure of electrical
and electronic components.
IMPORTANT: If the fryer is not installed in a specifically designed
countertop, it must be mounted on metal legs and adjusted to be level,
both side-to-side and front-to-rear.
(p/n 20563: legs, metal adjustable, set of 4)
Apply teflon tape or high-temp sealant to the threaded portion of the
drain fitting on the bottom of the fryer, and to the threaded portion of
the drain extension and coupling. Screw the frypot drain valve onto the
fitting on the bottom of the frypot, and assemble the drain extension
and coupling to the drain valve.
Set the frypot into the fryer. Be sure the valve is closed (valve handle
horizontal).
Refer to the Installation Instruction Sheet for required clearances.
Maintain required clearances between the appliance and adjacent
combustible surfaces.
Contact a licensed electrician to install an appropriate electric circuit
and connect electrical power to the appliance.
Avoid storing flammable or combustible materials in, on or near the
appliance.
1 ea.
1 ea.
page 4 of 10
Drain Extension
Drain Coupling
Advertisement
Table of Contents
