Nortel NN43001-504 Installation Manual page 133

Message
No Host IP (Addr)
No IP Address
No Net Access
No Net Found
(For the WLAN Handsets
2210/2211/ 2212 only.)
No Net Found
(For the WLAN Handsets
6120/6140 only.)
Copyright © 2004-2007, Nortel Networks
.
Description
The wireless handset is
configured for static IP (as
opposed to use DHCP) and
no valid host IP address (the
wireless handset IP address) is
entered.
Invalid IP address.
Cannot authenticate or
associate with AP.
This indicates any of the
following:
• No radio link
• No ESSID—Autolearn
not supported (or)
incorrect ESSID
• AP does not support
appropriate data
ranges
•
Out of Range
• Incorrect WEP settings
•
Incorrect Security
settings
This indicates any of the
following:
• No radio link
• No ESSID—Autolearn
not supported (or)
incorrect SSID
•
AP does not support
appropriate data
ranges
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Dropped calls 133
Action
Enter a valid IP address in
the configuration settings or
change to use DHCP.
Check the IP address of
the wireless handset and
reconfigure if required.
Verify the AP configuration.
Verify that all the WEP settings
in the handset match those in
the APs.
Verify that the AP is turned on.
Verify the ESSID of the wireless
LAN and enter or Autolearn it
again, if required.
Check the AP configuration
against the AP Configuration
Note.
Try getting closer to an AP.
Check to see if other handsets
are working within the same
range of an AP. If so, check the
ESSID of the handset.
Verify that all the WEP settings
in the handset match those in
the APs.
Verify that all the Security
setting in the AP.
Verify that the AP is turned on.
Verify the SSID of the wireless
LAN and enter or Autolearn it
again, if required.
Check the AP configuration
against the AP Configuration
Note.