Nortel DCT1900 Technical Product Manual page 232

Technical Product Manual - DCT1900
Installation Instructions, Base Station – KRC 101 1371
6. Screw in the two 1/4-20 screws with the captured star washers as shown. Check that the
assembly is locked to the base station.
7. Twist the ceiling clips clockwise and then back counterclockwise onto the ceiling grid.
16.6.3 Base Station Mounting to Factory Ceiling (I Beams)
Direct mounting of the DCT1900 Base Station to an I beam in the ceiling is not allowed because of
the distortion caused to the radiated field pattern of the Base Station. Included in the following
discussion is a recommended method of securing the Base Station to the overhead while not
affecting the Base Stations' radiation pattern.
16-10
Fig. 16-9 Inserting Washers into Ceiling Bracket
Install-DCT1900/R8/mw
© 2000-2005