Table of Contents
Advertisement
Using the Passport 8100 Modules
Management Port
The Management port is a 10/100 Mb/s Ethernet port implemented on an RJ-45
connector wired as an MDI connection.
this connector.
Table A-1.
Connector
12345678
Console Serial Port
The Console serial port is implemented as a DB-9 connector. This port can
operate as a data terminal equipment (DTE) or data communication equipment
(DCE) device. Use the switch to the left of the port to set the port to DTE (left) or
DCE (right). Default settings for this port are 9600 bps, 8 data bits, no parity, and
one stop bit.
Because the Console port expects to receive Data Set Ready (DSR) and Clear To
Send (CTS) signals before transmitting, these control lines are required in the
cabling. The Console port does not support any inbound flow control; that is, the
port does not toggle control lines to indicate an input buffer full condition.
A-4
Pin Assignments in the Passport 8190SM Management Port
Pin Number
1
2
3
6
8020EA
4, 5, 7, 8
Table A-1
shows the pin assignments for
Signal
Output transmit data + (TX+)
Output transmit data - (TX-)
Input receive data + (RX+)
Input receive data - (RX-)
Not used
204515-C
Advertisement
Table of Contents
