Table of Contents
Advertisement
Using the Passport 8100 Modules
Note: Nortel Networks recommends using the Passport 8190SM module to
configure and manage your switch. The Comm port on the Passport 8132TX
module is active only when no Passport 8190SM module is present and when
the Passport 8132TX module is operating as the master module.
The Comm port on the Passport 8132TX module is configured as a data
communications equipment (DCE) connector. Be sure that your RS-232 cable
pinouts are configured for DCE connections.
LEDs
The Passport 8132TX module has LEDs
status of the ports and the module. Each port has two integrated LEDs to indicate
link speed and activity for that port. In addition, the module has three LEDs to
indicate system operating conditions.
1
Figure 1-4.
For more information about LED operation, refer to
1-10
2
3
9120EA
LEDs on the Passport 8132TX Module
(Figure
1-4) to indicate operational
1 = Module LEDs
2 = Port Speed LEDs
3 = Port Link/Activity LEDs
Appendix B,
"LEDs."
204515-C
Advertisement
Table of Contents
