Nortel VPN Router 2750 Installation Manual page 73

This section provides instructions on adding a second DIMM to the VPN Router
2750 or, if necessary, replacing an existing DIMM.
Caution: Use of a memory module not purchased from Nortel can
render void your warranty or your service contract.
Caution: Ensure that you install the same type of DIMM that is already
installed in your gateway.
To install or replace a DIMM:
1
Shut down the VPN Router 2750 using the Web GUI or the CLI, and then
unplug it as described in
hardware" on page
Warning: Risk of electric shock
Turn off the VPN Router 2750 and unplug it before you attempt to install
a DIMM.
2 Remove the front bezel from the chassis, and then remove the chassis from the
equipment rack (see
3
Remove the top cover from the chassis (see
top cover" on page
4 Attach the antistatic wrist strap that was shipped with the VPN Router 2750
(see "Attaching the antistatic wrist strap" on page
Caution: Risk of equipment damage
Electrostatic discharge can damage VPN Router 2750 components.
Chapter 4 Installing option cards and DIMMs 73
"Shutting down the system to add or replace
62.
"Removing the front bezel and top cover" on page
63).
Nortel VPN Router Installation — VPN Router 2750
"Removing the front bezel and
67).
63).