Connect To Gas Supply - Fisher & Paykel CG604DX Installation Instructions Manual

2
!0 FIT CLAMPING BRACKETS BASED ON THE
BENCHTOP THICKNESS
x 4
view from below
16-20mm
Elbow (½" BSP external thread)
recessed to 50 mm
+50 mm
20-30mm 30-40mm
1
20-30mm 30-40mm
!2
NG
Adjust to obtain a test point
pressure of 20 mbar with all
the burners operating at
Arrow
highest setting.
ALL Models
Make sure the connection point will be accessible with the cooktop installed.
To enable the gas supply to be readily shut o by the customer, make sure
the connection is fitted with an isolating valve close to the cooktop.
If connecting the gas with a flexible hose:
Ensure the hose is long enough to allow for removal of cooktop for servicing.
Make sure the connector is located as shown in step 5 CLEARANCE DIMENSIONS.
Hose assembly must be AS/NZS 1869 Class B or D certified, with an Rp ½" (ISO 7 1) female thread connection.
40mm+
Hose assembly must be as short as practicable and comply with relevant AS 5601/NZS 5261 requirements.
Hose must not be kinked, subjected to abrasion or permanently deformed.
Hose must not be near or in contact with any hot surfaces
(e.g. base of metal hotlplate, flue, or chassis of underbench oven etc.)
Adhesive side
40mm+

CONNECT TO GAS SUPPLY

LPG
If converting to LPG, see 16 'Converting to a di erent gas type'
Make sure the supply pressure
is regulated to 29 mbar, with
all the burners operating at
highest setting.
lifting o
!1 SECURE TO BENCHTOP
lifting o
Foam Tape
2
Repeat on all the other sides
yellow tip
good ame
x 4
yellow tip
good ame
x 4
9