Husqvarna CR 125 2010 Manual page 118

HEADLAMP BULBS REPLACEMENT (WR)
To gain access to the healamp bulbs, proceede as follows:
- remove the upper fastening screw of the the headlamp carrier
to the instrument panuel support (A);
- push forward the headlamp carrier (B) and pull it towards the
high (C) in order to uncouple from the two lower supports.
- remove the headlamp carrier;
C
B
54
- remove the two filaments bulb (7) connector (2) and the
boot (3);
- remove the screw (6);
- release the bulb holding spring (4) and then the bulb itself.
To replace the parking light bulb (5) extract it from the inside
cover.
After replacement, reverse operations for reassembly.
A
2
5
4
3
TAIL LIGHT (WR)
The back light is a LED light.
5
4
3
7
6