Husqvarna CR 125 2010 Manual page 105

PADS CLEANING
Be careful that no disc brake fluid or any oil gets on brake
pads or discs. Clean off any fluid or oil that inadverently gets
on the pads or disc with alcohol.
Replace the pads with new ones if they cannot be cleaned satis-
factorily.
PADS INSTALLATION
- Install new brake pads.
- Reassemble the two pins (2) and the springs (1).
1
WARNING!
Do not attempt to ride the motorcycle until
the brake lever or pedal are
fully effective. Pump the brake lever or
pedal until the pads are against the discs.
The brake will not function on the first ap-
plication of the lever or pedal.
FRONT
2
REAR
2
1
41