Husqvarna CR 125 2010 Manual page 109

- Pump with brake lever (3) or brake pedal (3A) in order to
push brake fluid out of line.
- Close the bleeding valve and fill the reservoir with fresh
brake fluid.
- Open the bleeding valve, apply the brake using the brake
lever or pedal, close the bleeding valve with the brake lever
or pedal applied and then quickly release the lever or pedal.
- Repeat this operation until the brake line is filled and clear
fluid starts coming out of the plastic hose: now close the
bleeding valve.
- Restore the brake fluid level (A) or (B) then reassemble the
rubber and the fluid reservoir cap.
After the brake fluid replacement, it is necessary to operate
the braking system bleeding (see pages 46 and 48).
3A
45