Connecting The Ip Phone 1535 To The Lan; Enabling The Lan Connection Profile; Nortel Communications Servers Nortel Ip Phone 1535 Installation And Commissioning - Nortel IP Phone 1535 Installation And Commissioning Manual

26 First time installation of the IP Phone 1535
Step
1
2

Connecting the IP Phone 1535 to the LAN

To connect the IP Phone 1535 to a LAN you must make an RJ-45
connection.
Step
1
2
Enabling the LAN connection profile
To establish an active network connection, you must configure the IP Phone
1535 to operate in either of two network connection profiles: LAN or WiFi.
The IP Phone 1535 is preconfigured to make a network connection using
LAN over an Ethernet switch or router. Thus, the LAN connection profile is
enabled on the IP Phone 1535 by default.
Step
1
2
3
Copyright © 2009, Nortel Networks
.
Action
From the Main Menu, select Settings > System Settings > Admin,
and press OK.
Select Logout, and press OK.
Action
Insert the RJ-45 cable into the LAN port at the back of the IP Phone
1535.
Connect the other end of the LAN cable into an active LAN
connection port on the network.
Action
From the Main Menu, select Settings >Profile and press OK.
Select LAN >Enable (the LAN connection profile is enabled on the
IP Phone 1535 by default).
When asked to confirm the change, select Yes to accept.
Nortel Communications Servers
Nortel IP Phone 1535 Installation and Commissioning
NN43160-300 02.03 Standard
Release 4.0/SN10 28 October 2009
—End—
—End—
—End—