[Line Parameter Setting] - Olivetti d-COLOR MF3300 Utility Keys

5.8 [Fax Settings]

[Line Parameter Setting]

To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Line Parameter Setting]
Configure the environment to use fax functions on this machine, such as the types of telephone lines (dialing
method) and fax receive mode.
Settings
[Dialing Method]
[RX Mode ]
[Ring Pattern]
[Number of RX Call
Rings]
[Number of Redials]
[Redial Interval]
[Line Monitor]
[Line Monitor Sound
Volume (Send)]
[Line Monitor Sound
Volume (Receive)]
[Manual RX V.34 OFF]
d-Color MF 3300/3800
Description
Select the line type according to your environment.
The default value depends on the region the machine is used in.
Select a receive mode.
• [Auto RX]: Automatically start receiving a fax if the call is a fax call.
• [Manual RX]: Manually request the reception of a fax. Select this option
when this machine is used with a telephone connected to it, which is fre-
quently used, and if you always prefer to receive faxes manually.
[Auto RX] is specified by default.
Select a fax ring pattern when the DRPD (Distinctive Ring Pattern Detection)
service is used.
When this machine receives a call signal of the selected pattern, fax receiving
starts automatically.
[Normal Ring] is specified by default.
Note
In general use, set this to [Normal Ring]. If DRPD is set by mistake in a region
where DRPD cannot be used, it will result in a fax receiving failure.
If necessary, change the number of times the phone rings before automatically
receiving a fax.
The default value depends on the region the machine is used in.
If the machine fails to send a fax successfully, it automatically redials the same
destination after a certain period of time has elapsed. If necessary, change the
number of redials.
The default value depends on the region the machine is used in.
If necessary, change the redial intervals when you specified a value in [Number
of Redials].
[3 min.] is specified by default.
Select whether or not to play sounds on the telephone line from speakers dur-
ing fax communication.
[OFF] is specified by default.
Monitors sounds output from the machine. Specify the monitor sound volume
between 0 and 8.
This function is available only when [Line Monitor] is set to [ON].
[3] is specified by default.
Note
When communicating with fax, monitoring sound is generated even if send or
receive monitoring sound of this machine is set to [0] since the sound is gen-
erated both on this machine and on the destination side. For setting to mute,
set both [Line Monitor Sound Volume (Send)] and [Line Monitor Sound Volume
(Receive)] to [0], or set [Line Monitor] to [OFF].
Monitors sounds output from the recipient, including switching equipment or
TA. Specify the monitor sound volume between 0 and 8.
This function is available only when [Line Monitor] is set to [ON].
[4] is specified by default.
Note
When communicating with fax, monitoring sound is generated even if send or
receive monitoring sound of this machine is set to [0] since the sound is gen-
erated both on this machine and on the destination side. For setting to mute,
set both [Line Monitor Sound Volume (Send)] and [Line Monitor Sound Volume
(Receive)] to [0], or set [Line Monitor] to [OFF].
Select whether or not to automatically release the V.34 mode when manually
receiving a fax (G3).
[Enable] is specified by default.
5
5-23