Epson DLQ-3500 Reference Manual page 37

Note:
When Overlapping Forms is turned on in the default-setting
mode, the printer automatically activates the auto paper thickness
function even though the paper-thickness lever may be set to another
position.
3. Follow the instructions in "Loading continuous paper with
the tractor" on page 1-9.
Caution:
c
❏
❏
To tear off and eject overlapping multipart forms with labels
Always tear off and eject overlapping multipart forms with labels
by following the procedure below.
Note:
When Overlapping Forms is turned on in the default-setting mode,
the Tear Off/Special Paper button is disabled and the Load/Eject
button only feeds forms forward.
1. At the back of your printer, tear off the last overlapping
multipart form with labels that has entered the printer.
2. Press the LF/FF button to eject the last form forward.
3. To print on another type of paper, turn off Overlapping
Forms and Skip over perforation settings in the
default-setting mode.
Printing on the edge of overlapping multipart forms with
labels can damage the print head.
When loading overlapping multipart forms with labels, make
sure the left edge of the form is no further than 3 cm to the
left of the arrow mark (when facing the back of the printer).
Paper Handling
1-31