Epson DLQ-3500 Reference Manual page 30

To tear off and eject overlapping multipart forms
Always tear off and eject overlapping multipart forms following
the instructions described below.
Note:
When Overlapping Forms is turned on in the default-setting mode,
the Tear Off/Special Paper button is disabled and the Load/Eject
button only feeds forms forward.
1. At the back of your printer, tear off the last overlapping
multipart form that has entered the printer.
2. Press the LF/FF button to eject the last overlapping multipart
forms forward.
Labels
When selecting labels for printing, always choose labels mounted
on continuous backing sheets with sprocket holes for use with a
tractor. Do not use labels on shiny single-sheet backing, because
the backing sheet tends to slip and may not feed properly.
Follow these steps to load labels:
Caution:
c
Use labels only under normal operating conditions because labels
are especially sensitive to temperature and humidity.
1. Make sure of the following:
❏
Your software settings keep the printing entirely within
the printable area. For information about the printable
area, see "Printable area" on page A-24.
c
1-24
Paper Handling
Caution:
Printing on the edge of a label can damage the print head.