Adjusting The Footrest Height; Model Pw93, Pw93E, And Pw93St Footrests - Invacare nutron R51 Owner And Maintenance Manual

3. Repeat STEPS 1-2 for the opposite side of the wheelchair.
Footrest Release Lever
Hinge Pins

Adjusting the Footrest Height

Model PW93, PW93E, and PW93ST Footrests

NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing the Footrests
on page 36.
NOTE: Lay footrest on a flat surface to simplify procedure.
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired height.
5. Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest
support. Tighten securely.
6. Repeat STEPS 1-5 for the other footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing the
Footrests on page 36.
8. Reinstall any accessory onto the footrest(s).
Part No. 1106645
Footrest Hinge Plate
FIGURE 7.1 Installing/Removing the Footrests
SECTION 7—FRONT RIGGINGS
37
R51™and R51LXP