Reaching, Leaning And Bending - Forward; Reaching And Bending - Backward - Invacare nutron R51 Owner And Maintenance Manual

Reaching, Leaning and Bending - Forward

NOTE: For this procedure, refer to FIGURE 4.2 on page 25.
Many activities require the wheelchair user to reach, bend and transfer in and out of the
wheelchair. These movements will cause a change to the normal balance, center of gravity,
and weight distribution of the wheelchair. To determine and establish your particular
safety limits, practice bending, reaching and transferring activities in several
combinations in the presence of a qualified healthcare professional before attempting
active use of the wheelchair.
1. Position the front casters as far forward as possible.
2. Engage clutches and, if applicable, wheel locks*.
Risk of Serious Injury or Damage
Improper positioning while leaning or bending could cause the wheelchair to tip
forward resulting in serious injury or damage.
To assure stability and proper operation of your wheelchair, you must at all times
maintain proper balance. Your wheelchair has been designed to remain upright and
stable during normal daily activities as long as you DO NOT move beyond the
center of gravity. DO NOT lean forward out of the wheelchair any further than the
length of the armrests.
DO NOT attempt to reach objects if you have to move forward in the seat or pick
them up from the floor by reaching down between your knees.
FIGURE 4.2

Reaching and Bending - Backward

DO NOT lean over the top of the back upholstery. This will change your center of
gravity and may cause you to tip over.
NOTE: For this procedure, refer to FIGURE 4.3.
Part No. 1106645
SECTION 4—SAFETY/HANDLING OF WHEELCHAIRS
WARNING
Reaching, Leaning and Bending - Forward
WARNING
25
R51™and R51LXP