Hyundai 2016 Azera Owner's Manual page 133

Reprogramming a single
HomeLink ® button
To program a device to HomeLink
using a HomeLink ® button previously
trained, follow these steps:
1. Press and hold the desired
HomeLink ® button. DO
release the button.
2. The indicator light will begin to
flash after 20 seconds. Without
releasing the HomeLink
proceed with "Programming" step
2.
For questions or comments, contact
HomeLink ® at www.homelink.com or
1-800-355-3515.
Erasing HomeLink
Individual buttons cannot be erased.
® However, to erase all three pro-
grammed buttons:
1. Press and hold the two outer
HomeLink ®
NOT cator light begins to flash after 10
seconds.
2. Release both buttons. Do not hold
for longer than 20 seconds.
® button,
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be pro-
grammed at any time following the
appropriate steps in the Programming
sections above.
® buttons FCC ID: NZLTLMHL4
IC: 4112A-TLMHL4
This device complies with Part 15
of the FCC Rules.
buttons until the indi-
Operation is subject to the following
two conditions:
1. This device may not cause harm-
2. This device must accept any inter-
®
Wireless
The transceiver has been tested
and complies with FCC and
Industry Canada rules. Changes
or modifications not expressly
approved by the party responsi-
ble for compliance could void
the user's authority to operate
the device.
Features of your vehicle
ful interference, and
ference received, including inter-
ference that may cause undesired
operation.
WARNING
4 53