Hyundai 2016 Azera Owner's Manual page 131

Programming
To train most devices, follow these
instructions:
Flashing
1. For first-time programming, press
and hold the two outside buttons
( , ), HomeLink ® Channel 1
and Channel 3, until the indicator
light begins to flash (after 10 sec-
onds). Release both buttons. Do
not hold the buttons for longer
than 20 seconds.
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
OYF042252N
you wish to program while keeping
the indicator light in view.
3. Simultaneously press and hold
both the HomeLink
held transmitter buttons until the
®
HomeLink
from a slow to a rapid blinking light.
Now you may release both the
®
HomeLink
mitter buttons.
✽ ✽ NOTICE
Flashing
Some devices may require you to
replace this Programming step 3
with procedures noted in the "Gate
Operator/Canadian Programming"
section. If the HomeLink
light does not change to a rapidly
blinking light after performing these
steps,
www.homelink.com.
OYF042251N
®
button
®
and hand-
indicator light changes
and hand-held trans-
Features of your vehicle
® indicator
contact HomeLink ® at
4 51