Hyundai 2016 Azera Owner's Manual page 132

Features of your vehicle
4. Firmly press, hold for 5 seconds
and release the programmed
HomeLink ® button up to two sepa-
rate times to activate the door. If
the door does not activate, press
and hold the
®
HomeLink button and observe
the indicator light.
• If the indicator light stays on con-
stantly, programming is complete
and your device should activate
when the HomeLink
pressed and released.
• If the indicator light blinks rapidly
for 2 seconds and then turns to
a constant light, continue with
"Programming" steps 5-7 to
complete the programming of a
rolling code equipped device
(most commonly a garage door
opener).
5. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
4 52
6. Firmly press and release the
"learn" or "smart" button. (The
name and color of the button vary
by manufacturer). There are 30
seconds to initiate step 7.
just-trained
7. Return to the vehicle and firmly
press, hold
and release the programmed
HomeLink
"press/hold/release" sequence a
second time, and, depending on
® button is the brand of the garage door
opener (or other rolling code
equipped device), repeat this
sequence a third time to complete
the programming process.
HomeLink ®
rolling code equipped device.
for 2 seconds
® button. Repeat the
should now activate your
Gate operator & Canadian
programming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press
the Integrated HomeLink ®
Control System button (note steps
2 through 4 in the Standard
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
®
Operating HomeLink
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Wireless
® button.