Winterising/Dry Storage; Limited Warranty; Cooling System - Williams DieselJet 445 Owner's Handbook Manual

Hide thumbs Also See for DieselJet 445:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Servicing
The important post run-in 1st service is required at 50 hours. Thereafter servicing is
required according to Maintenance Table or yearly, whichever comes first. Consult your
Williams authorized dealer for servicing. Refer to the Yanmar service manual for periodic
engine maintenance.
For parts and accessories please contact your Williams authorized dealer.

Winterising/Dry Storage

Store the boat covered, in a clean, ventilated and dry place that is not affected by major
variations in temperature or humidity. This is a general best practice guide. For full
information on engine maintenance please refer to the YANMAR engine service manual.
Buoyancy Tube
Prior to storing over the winter periods the buoyancy tubes must be deflated and hosed down
with fresh water, removing any small stones and weed from luffing track, then allowed dry. Use
a proprietary tube cleaner and polish to ensure optimum condition. Store with the tubes lightly
inflated where possible.
Maintenance of the Hull & Deck
Wash the deck regularly using a mild detergent in warm water and hose down to remove sand
etc. The hull and deck should be regularly polished using a good quality gelcoat polish to
minimise fade and UV chalking.
Battery
The battery used in the Dieseljet is of the dry cell type and as such if replacing the battery
ensure an AGM type is used. This means that the electrolyte content is absorbed in a special
fabric which requires no 'topping up' and is leak proof in any position. When the boat is not
being used for an extended period of time, disconnect the earth terminal. A trickle-charging
device, such as an 'Accumate', will extend battery life.
Fuel System
A full fuel tank prevents moisture and mildew from developing within the tank. Drain water from
fuel separator.

Cooling System

Flush the open loop water circuit to remove salt, sand, shells and other contaminants that
may be trapped in the raw water cooling circuit (refer to Flushing Procedure section). Remove
engine raw water impeller if not in use for long periods. Measure the anti-freeze content of
the engine coolant with a commercially available anti-freeze tester. A 50/50 mixture of distilled
water to propylene glycol provides sufficient frost protection to approx. -37°C, drain raw water
from engine OR run the same 50/50 antifreeze mixture through the open loop system via
the raw water strainer and with the isolator valve in the OFF position. See engine manual for
location of engine drain cocks.
Control Cables
Grease all control cables at both ends and exercise in and out to ensure good coverage.
General Corrosion Protection
Apply 'Vaseline' or similar white grease to battery isolator switch, upholstery press studs and
telescopic running light. Use maintenance spray on key switch. Apply a proprietary corrosion
guard to engine, electrical connections, under seat, under helm and around jet pump area.
22
www.williamsjettenders.com

Limited Warranty

Williams Performance Tenders Ltd. 2012 Model Year Limited Warranty Certificate
Williams Performance Tenders ("Williams") undertake a PDI (pre-delivery inspection) on all new boats before shipment
from factory. Williams will provide for repairs to their inflatable boats during the specific warranty periods provided herein,
in accordance with the following terms, conditions and limitations. Registration of Williams boat – Each Williams boat is
supplied to the original customer with a registration card. The limited Warranty contained herein shall not take effect and
shall be deemed null and void unless the original owner submits a completed registration card to Williams Performance
Tenders Ltd, Unit 2 Vogue Business Park, Berinsfield, Oxon OX10 7LN. UK within 30 days from the date of original
registration. Williams approved dealers shall be entitled to store boats for a period of up to 6 months prior to registration
provided that: a) The boats are stored in original packaging in accordance with Williams guidelines; b) Registration is
recorded upon handover with delivery hours only.
Warranty coverage:
Williams warrants to the original private purchaser of a properly registered craft that: a) All seams of the tubes, inflation
valves, and the fabric used in the construction of the tube shall be free from defects in material and workmanship for a
period of 3 years from the date of the original registration; b) The fabric of the tube shall be free from deterioration affecting
serviceability (i.e. cracking, porosity, but not discolouration, fading or chaffing) for a period of 3 years from the date of the
original registration; c) the fibreglass hull shall be free from defects in material and workmanship for a period of 2 years from
the date of the original registration; d) all components fitted to the boat at the Williams factory or subsequently replaced
under warranty shall be free from defects in material and workmanship for a period of 2 years from the date of the original
registration. The warranty period for commercial use owners will be 4 months from the date of original registration. The
obligation of Williams under this Limited Warranty is limited to repairing or replacing, as Williams may elect at its sole
discretion, any parts that prove, in Williams' sole judgement, to be defective in material or workmanship. THIS LIMITED
WARRANTY SHALL BE THE ORIGINAL PURCHASER'S SOLE AND EXCLUSIVE REMEDY.
What is not covered:
This Limited Warranty shall not apply to: a) normal wear and tear; b) any minor boat damage, including but not limited to,
gel coat crazing, fading or blistering; c) Any damage to Williams boats due to negligence, accident, misuse, alteration,
improper operation, collision, fire, theft, vandalism, riot, explosion, objects striking the boat, improper maintenance and
storage; d) Any damage caused by towing a Williams boat, any damage caused by lifting or recovering a Williams boat;
e) Tubes exposed to harsh or corrosive chemicals; f) any parts installed by anyone other than Williams factory personnel;
g) any damage caused by after-market parts; h) Williams boats purchased for commercial/governmental use; i) any work
carried out on a Williams boat by an unauthorised service centre and/or without Williams' prior approval; j) labour, freight,
delivery, storage or other similar charges; k) defects caused or worsened by failure to adhere to the instructions concerning
the treatment, maintenance and care of the boat; l) Damage caused by water ingestion. Sometimes equipment installed
on a Williams boat (such as electronics) carry their own individual warranties provided by their respective manufacturers. In
such cases any warranty claims regarding those parts must be directed to those manufacturers and not Williams. Williams
reserves the right to make warranty coverage contingent upon proof of proper maintenance.
How to obtain Warranty repair:
Prior to any work being commenced on a Williams boat, the warranty claim must be approved in writing by Williams
Performance Tenders Ltd. In order to obtain warranty repair approval, the original owner must send written notification,
along with a copy of the bill of sale, and photograph depicting the damage and/or defect sought to be repaired to Williams
Performance Tenders Ltd, Unit 2 Vogue Business Park, Berinsfield, Oxon OX10 7LN. U.K. If Williams finds that the specific
defect and/or damage is covered under this Limited Warranty, Williams will advise the owner in writing where to send (via
pre-paid freight) the boat or part(s) for repair or replacement. In many cases the local authorised Sales and Service Centre
may be utilised for repairs. In others the boat or parts must be repaired by Williams personnel only. Williams does not
assume any liability for any work performed on a Williams boat at an unauthorised Service Centre and/or without Williams'
prior approval. All parts replaced under this Limited warranty become the property of Williams.
Miscellaneous:
Williams does not authorise any person to create for it any other obligation or liability in connection with its boats. THIS
LIMITED WARRANTY AND WILLIAMS' OBLIGATION HEREUNDER IS IN LIEU OF ALL WARRANTIES EXPRESS OR
IMPLIED, INCLUDING WITHOUT LIMITATION THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. Williams will not be liable for any incidental or consequential damages resulting from breach
of this limited warranty, including without limitation, loss of inflatable boat use, storage, payment for loss of time,
inconvenience, boat rental expense, and local taxes required on warranty repairs. Williams reserves the right to alter
models, change colors, specifications, materials, equipment, component parts, prices or cease production of certain
models at any time without prior notice, and such changes, alterations, or cessation shall be made without Williams
incurring any obligations to equip or modify inflatable boats produced prior to the date of such changes or alterations. This
Limited Warranty shall be governed by and construed and enforced in accordance with UK Law.
23
www.williamsjettenders.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dieseljet 505Dieseljet 565Dieseljet 625

Table of Contents