CE plate is located in the starboard rear footwell. The CE plate is the certification to European The Williams Minijet uses water jet propulsion. If this is your first boat or you are changing to Directive 94/25/CE. This boat is also compliant with US Coastguard and ABYC regulations.
Williams suggest that after the first 10 hours of WARNING. Manoeuvrability of the boat is restricted while decelerating. Familiarize operation, the engine be checked by an authorized Williams dealer.
Check engine cover latches are secure. whether the overheating is from the engine or exhaust. Return to port as soon as possible and contact your nearest Williams dealer. Power Limit Switch The Check Engine (3) indicator light is illuminated when an active fault has been detetcted somewhere in the system.
4 Run the engine for about 20 seconds, between 4000 and 5000 rpm. 5 Ensure water flows out of jet pump whilst flushing. Otherwise, contact your authorized Williams Dealer. 6 Turn off tap. 7 Allow the engine to run on for no longer than 10 seconds to allow water to exit from the cooling system, then turn off the engine.
Risk of injury or death. When Williams lifting strops are used, please responsibility for damage or injury resulting from incorrect maintenance or improper adhere to the Safe Working Load values as follows: Minijet 280: 280 kg max. adjustment carried out by the owner.
Full Inspection Maintenance Table First Every Every To be 50 hours 100 hours 200 hours carried or 1 year or 1 year or 2 years out by Please use this section for servicing guidance and the Rotax engine manual for all engine- related serviceable items.
Fuel will become stale over a period of several months. A full fuel tank prevents moisture and as Williams may elect at its sole discretion, any parts that prove, in Williams’ sole judgement, to be defective in material or workmanship. THIS LIMITED WARRANTY SHALL BE THE ORIGINAL PURCHASER’S SOLE AND EXCLUSIVE REMEDY.
Page 11
2 anni dalla data di registrazione. La Williams Performance Tenders si riserva il diritto di riconoscere eventuali lavori in garanzia previa verifi ca di corretta e costante manutenzione.