Cannot Print Over A Network - Canon iPF825 User Manual

Cannot print over a network

Cannot connect the printer to the network ................................................................................................ 809
Cannot print over a TCP/IP network .......................................................................................................... 809
Cannot print over a NetWare network ....................................................................................................... 809
Cannot print over AppleTalk or Bonjour networks ..................................................................................... 810
Cannot connect the printer to the network
Cause
The Ethernet cable
is not connected
correctly to the
printer's Ethernet
port.
Cannot print over a TCP/IP network
Cause
The printer's IP address is not
configured correctly.
The printer's TCP/IP network
settings are not configured cor-
rectly.
The computer you are trying to
print from is not configured cor-
rectly.
Cannot print over a NetWare network
Cause
The printer's NetWare
settings are not config-
ured correctly.
iPF825
1. Make sure the printer is connected to the network with the correct Ethernet cable, and
then turn the printer on. For instructions on connecting the cable, refer to the Setup Guide.
2. Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100 Base-TX and orange if con-
nected via 10Base-T.
If the Link indicator is not lit, check the following points.
• Make sure the hub is on.
• Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
• Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
• Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission
rate automatically (in auto negotiation mode), sometimes the hub settings cannot be de-
tected. In this case, configure the connection method manually, specifying the commu-
nication mode in use.
(See "Configuring the Communication Mode Manually.")
Make sure the printer's IP address is configured correctly.
(See "Configuring the IP Address Using imagePROGRAF Device Setup
Utility.")
→P.382
(See "Configuring the IP Address Using the Printer Control Panel.")
→P.715
Make sure the printer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer's TCP/IP Network Settings.")
Make sure the computer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer Driver Destination .")
(See "Configuring the Destination for TCP/IP Network .")
Make sure the printer's NetWare settings are configured correctly. In particular, make
sure a valid frame type is selected.
(See "Configuring the Printer's NetWare Network Settings.")
Troubleshooting > Cannot print over a network
Corrective Action
Corrective Action
Corrective Action
Cannot connect the printer to the network
>
→P.720
→P.717
→P.723
→P.735
→P.724
12
809