Canon iPF825 User Manual page 377

Setting
30sec. / 1min. / 3min. / 5min. /
10min. / 30min. / 60min.
Between Scans
This sets the wait time between line scans during printing.
Setting
Printer Default
None
1sec. / 3sec. / 5sec. / 7sec. /
9sec.
Roll Paper Margin for Safety
Near End Margin
This sets the length of the near end margin of the roll paper.
Setting
Printer Default
3mm
20mm
Important
• If you make the margin (white space) too small, this could disturb the print image or cause the printhead
to scour the surface of some types of media. If the printhead scours the surface of the media, adjust the
height of the printhead.
Cut Speed
This selects the auto cut speed.
Setting
Printer Default
Fast
Standard
Slow
iPF825
The sheet is ejected when the specified time after printing has elapsed.
The settings of the printer operating panel are applied.
The printing continues to the next line immediately after the last line.
The printing continues to the next line after the set time.
*For the media type that has problems, such as ink smears on the page or colors
that seem uneven during borderless printing etc., increase the value for this set-
ting.
The settings of the printer operating panel are applied.
Print at a standard size.
*Select for Media Type that has no problem when printing with a standard size
margin.
This setting sets the margin about 17 mm (in the feed direction) longer than the
standard margin for the media size.
*This is for Media Type that has a strong tendency to curl, causing the printhead
to scratch the surface.
The settings of the printer operating panel are applied.
Select this setting if cutting with the Standard setting is not clean.
Select this setting when you are not experiencing problems.
Select this setting if cutting with the Standard setting is not clean.
Windows Software
Details
Details
Details
Details
Paper Detailed Settings
> HDI Driver >
4
361