Other Maintenance - Canon iPF825 User Manual

Maintenance >

Other Maintenance

Other Maintenance
Preparing to Transfer the Printer ............................................................................................................... 776
Updating the Firmware .............................................................................................................................. 782
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow the steps below before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Important
• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and
damage the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Note
• It is not possible to prepare the printer for transfer if the Display Screen requests Maintenance Cartridge
replacement or checking of the remaining capacity. Replace the Maintenance Cartridge before transfer
preparations. (See "Replacing the Maintenance Cartridge.")
• Depending on the state of the printer, part replacement may be necessary when preparing to transfer the
printer (that is, when you execute the printer menu item to prepare for transfer).
• Ink must be drained before Level 2 or Level 3 printer transfer, as described in the following table. Pre-
pare a Maintenance Cartridge in advance.
• Always follow the instructions of the service representative when transferring the printer under Level 3
conditions.
11
776
Preparing to Transfer the Printer
>
Shipping
Level Method (Ex-
ample)
1 By truck Lengthwise: 0°–30°
Rotation: 0°–10°
2 By plane All directions: 0°–30°
3 Tipping the Lengthwise: 0°–90°
printer or hold- Rotation: 0°–30°
ing it upright
for elevators or
stairs
→P.763
Permitted Angle of Inclination
Required
Amount of
Mainte-
Ink to Dis-
nance Car-
pose of
tridges(*1)
0 0 or 1
Approx. 200 1 or 2
ml
Approx. 700 2 or 3
ml
iPF825