Brother HL-S7000DN User Manual page 120

Troubleshooting
Error message
No Tray ID XX
No Waste Tank
Output Tray Full
Paper Low Tray XX
Print Unable XX
Replace Parts
PF Kit MP
PF Kit XX
Size Error DX
Size Mismatch
Short paper
Small paper
Storage Error
Storage Full
Tray XX Error
Cause
The specified tray ID could not be
found.
The waste ink tank is not installed or
is installed incorrectly.
Output tray is full.
The paper in the tray is running low. Refill paper in the indicated paper tray.
The machine has a mechanical
problem.
It is time to replace the paper
feeding kit.
The paper size defined in the printer
driver and the control panel menu is
not available for automatic duplex
printing.
The paper in the tray is not the
correct size and is not available for
automatic duplex printing.
The paper in the indicated tray is not
the correct size.
The length of the paper in the tray is
too short for the machine to deliver it
to the face-down output tray.
The paper size specified in the
printer driver is too small for the
machine to deliver it to the
face-down output tray.
The storage memory is corrupted.
There is no space in the memory.
The paper tray is not installed in the
machine correctly.
Action
Confirm the tray ID assigned to the tray and select
that ID when printing.
Call your Brother dealer to re-install the waste ink
tank.
Remove printed pages from the output paper tray.
Turn the machine off, wait a few minutes, and then
turn it on again.
If the problem continues, call your Brother dealer.
Call your Brother dealer or a Brother Authorized
Service Center to replace the PF kit.
Press Cancel. Choose a paper size that is supported
by the duplex tray.
The paper sizes you can use for automatic duplex
printing are A4, Letter, Legal or Folio.
Load the correct size of paper in the tray and set the
size of paper for the tray. (See Paper Tray
uu page 79.)
The paper sizes you can use for automatic duplex
printing are A4, Letter, Legal or Folio.
Put the same size paper in the paper tray that is
selected in the printer driver, and then press Go, or
select the size of paper that you loaded in the
indicated paper tray.
Open the back cover (face-up output tray) to let the
printed paper exit onto the face-up output tray.
Remove the printed pages and then press Go.
Open the back cover (face-up output tray) to let the
printed paper exit onto the face-up output tray and
then press Go.
You can clear this error by turning the machine off,
and then turning it on again. Contact your
administrator to format the storage memory. If the
problem continues, call your Brother dealer.
Press Cancel or Go. Delete unnecessary macros or
fonts. (See Macro/Font uu page 81.)
Press Cancel or Go. Delete the previously stored
storage print data.
Completely pull out the paper tray indicated by the
message on the LCD, and then check inside the
machine and the tray for any paper. After checking,
re-install the tray correctly.
6
114