Brother HL-S7000DN User Manual page 119

Troubleshooting
Error message
Insufficient Ink
Jam MP Tray
Jam A Tray 1
Jam A Tray 2
Jam A Tray 3
Jam A Tray 4
Jam B Inside
Jam C Inside
Jam D Duplex
Jam E Rear
Jam F OP Tray
Limit Exceeded
Log Access Error
Low Temperature
Manual Feed
No Cartridge
No DX Tray
No Paper
Load <size> paper
in <tray>.
No Tray
Cause
The ink cartridge is at the end of its
life. The machine will stop all print
operations.
The paper is jammed in the area
indicated.
The number of pages you are
allowed to print has been exceeded.
The print job will be cancelled.
The machine could not access the
print log file in the server.
The room temperature is too low for
the machine to operate.
Manual was selected as the paper
source when there was no paper in
the MP tray.
The ink cartridge is not installed
correctly.
If you are using non Brother Original
ink the machine may not detect the
ink cartridge.
The duplex tray is not installed or
not installed correctly.
The machine is out of paper or
paper is not correctly loaded in the
specified paper tray.
The paper tray is not installed or not
installed correctly.
Action
Replace the ink cartridge. (See Replacing the ink
cartridge uu page 98.)
The printer's ink cartridge uses both Black ink and
Pre-coat to ensure print quality. Therefore if either the
Black ink or the Pre-coat runs out, the cartridge can
no longer be used and the printer cannot print, even
if there is some of the other ink remaining in the
cartridge.
See Paper jams uu page 116.
Contact your administrator to check your Secure
Function Lock Settings.
Contact your administrator to check the Store Print
Log to Network settings.
(For detailed information uu Network User's Guide:
Store Print Log to Network)
Increase the room temperature to allow the machine
to operate.
Place the same size of paper in the MP tray as is
shown on the LCD. If the machine is paused, press
Go. (See Loading paper in the multi-purpose tray (MP
tray) uu page 12.)
Take out the ink cartridge, and put it back into the
machine again.
Use a Brother Original ink cartridge.
Re-install the duplex tray.
Put paper in the indicated paper tray.
Make sure the paper guides are set to the correct
size.
Re-install the paper tray indicated in the LCD
message.
6
113